Lost operating hour meter

My operating hour meter count was reset on the switch channels after todays firmware upgrade to 7.10.
How can i restore them? I thought they where saved with the settings save...

Same here. All reset to zero.

Yes, i know some of the numbers to a certain degree. and i like to get them back. Better a little off then 0. Someone must know how to restore them....

Remember the sensor settings and the regular settings are two exports. Did you import both or the backup files?

yes both. so it should be restored if the data is stored in the backup. Anybody knows if it is?

the operation hour meter were not saved in previous versions

this has been changed now for all backups starting with firmware 7.10

but if you know your numbers there is a trick:

1. save all your settings with newest GCC

2. open the settings file with text editor (e.g. notepad)

3. search for these lines:
10284, "CODE_PROFILUX4_SP1_OHM - 0 - 0", 20477
10285, "CODE_PROFILUX4_SP1_OHM - 0 - 1", 17193
10286, "CODE_PROFILUX4_SP1_OHM - 0 - 2", 0
10287, "CODE_PROFILUX4_SP1_OHM - 0 - 3", 0
10288, "CODE_PROFILUX4_SP1_OHM - 0 - 4", 30
10289, "CODE_PROFILUX4_SP1_OHM - 0 - 5", 27252
10290, "CODE_PROFILUX4_SP1_OHM - 0 - 6", 765
10291, "CODE_PROFILUX4_SP1_OHM - 0 - 7", 27252
10292, "CODE_PROFILUX4_SP1_OHM - 0 - 8", 0
10293, "CODE_PROFILUX4_SP1_OHM - 0 - 9", 14589
10294, "CODE_PROFILUX4_SP1_OHM - 0 - 10", 17193
10295, "CODE_PROFILUX4_SP1_OHM - 0 - 11", 27252
10296, "CODE_PROFILUX4_SP1_OHM - 0 - 12", 14589
10297, "CODE_PROFILUX4_SP1_OHM - 0 - 13", 27252
10298, "CODE_PROFILUX4_SP1_OHM - 0 - 14", 27252
10299, "CODE_PROFILUX4_SP1_OHM - 0 - 15", 0
... etc.

these are the OHM for all 64 sockets

3. the last number is the time in hours - change them, save the file

4. load this file back to P4

-> we add the option to modifiy these numbers in a next GCC version

Yes ! Thanks Matthias
Thats was the answer i was looking for :)
Great

PS. Noticed the number was the time in minutes ;)

you are right, my mistake