0-10v port

Hi,

I have a problem about connecting the 0-10v cable to the Profilux 4, as the port in the pump controller is 3.5mm port. How could I adapt it?

PS: which kind of port on Profilux is for 0-10v control? RJ11/RJ12 with 6 pins? I could find some 4 pin RJ11/12 in the electric market, does it work if I got on 4-pin RJ11/12 cable to 3.5mm adapter?

Thank you very much!

This cable would have to be sourced from the pump manufacturer. If the other end of the cable does not fit into our 1-10v port, you can use our LBF-AP accessory.

One end of the cable will connect to your pump control outlet and the other end will be cut and connected to the LBF-AP board.

We provide the cable which goes from the LBF-AP to the P4.

Thanks for the reply.

Is LBF-AP able to connect multi pumps with different settings?

One LBF-AP accessory can control two separate channels. So yes, you can connect two separate pumps and control them individually.