Originally Posted by
Going Deep
Was this problem resolved? I installed the leakage interface and the leakage sensor yesterday following the P4 resource guide instructions. I have the red led light lit on the interface indicating that it is connected to the P4. It is connected to the "green" level port and level sensor at 3. The leakage sensor is connected and no light. When I set it to "leakage detection", I immediately get the alarm and the switch channels set to fill water (return pump and skimmer) turn off. I manually reset and the alarm immediately activates. I have tried all control units and even played with the sensor # and still get the same alarm. This happens only on the "leakage detection" setting. Similarly, when I disconnect the leakage interface from the P4, the alarm remains and does not reset. The alarm goes away if I deselect "leakage detection". Any advice would be appreciated.