How do I wire this extractor fan to GHL BoB?

I am installing a variable speed air extractor above my tank which will extract humid air to the outside. I want to run the extractor via my Profilux 4 and control the speed depending on the readings from the GHL temp/humidity sensor.

So I purchased a GHL break-out box but now have no idea on how to connect the extractor to the box for the 0-10V control (220v is supplied to the extractor separately).

Attached are five diagrams from the extractor documentation. My guess is the diagram number 26 is the one I want? But it only shows two wires, ground and 0-10v. can only two wires be connected to the GHL break-out box?

Help! :D

P0 -->GND Pin3 Breakoutbox
P1 --> Pin 2 or 5 Breakoutbox

Pin 2 if you use L1,L3.......
Pin 5 if you use want L2.L4.......

regards Pit

Fantastic... Thanks Pit, your help is much appreciated!

Soon I will also have the question as to how to program the Profilux to manage the extractor :-)

But I will start a new thread for that one...

GCC_System_1-10V Interface_Function_humidity sensor ?

regards Pit