Hi Matthias
May I know what is the pins configuration for the 1-10v port for ProfiLux Light controller?
I need it to connect my dimmable LED driver correctly.
Please kindly advice.
Thanks.
James.
Printable View
Hi Matthias
May I know what is the pins configuration for the 1-10v port for ProfiLux Light controller?
I need it to connect my dimmable LED driver correctly.
Please kindly advice.
Thanks.
James.
Hi James
the pin assignment can be found in the EVG-AP manual here:
http://www.aquariumcomputer.com/Down...G-AP2_V400.pdf
2 & 3 if using channel L1, 5 & 3 if using L2
What is pin 4 & 6 use for :rolleyes:?
additional signal for switching off relays at 0% brightness
L1 & L2 goes from 1 telepfone jack.
Lets say that in that jack there are 6 contacts, starting from left to right numbering 123456 (as in the picture bellow).
http://inlinethumb22.webshots.com/26...600x600Q85.jpg
Can you tell me which numbers are:
+10V for L1
Grd for L1
+10V for L2
Grd for L2
I want to make the jack so to connect 2 dimmable ballasts to dimm 2 T5 tubes.
small remark: L ports only have 4 contacts so your numbering would be 1,2,3,4 :-)
S ports do have 6 contacts
- this is not correct - all 6 pins are used for the L-portsQuote:
L ports only have 4 contacts so your numbering would be 1,2,3,4 :-)
pin 1 is on the left (view from rear)