How do I connect a Powerbar 6D PAB Profilux 3ex. I have put the network cable in and the yellow comm lamp blinkson the power bar, but I can't control it from my Profilux 3EX
/Peter
Printable View
How do I connect a Powerbar 6D PAB Profilux 3ex. I have put the network cable in and the yellow comm lamp blinkson the power bar, but I can't control it from my Profilux 3EX
/Peter
Did you assign the Powerbar to the ProfiLux as mentioned in the PAB guide in section 2.2?
On the ProfiLux:
System->Configure PAB->Assign devices
you can test if the sockets are reacting as expected:
use the "manual override" in ProfiLuxControl
No I don't have that option.Quote:
Originally Posted by Frank
http://www.aquariumcomputer.com/Foru...1&pictureid=43
PLC currently doens't support to configure PAB devices (once they are 'discovered' you can configure them normally in PLC )
PLz check this thread for more info about PAB
http://www.aquariumcomputer.com/Foru...ead.php?t=1395
OK now I've contact to tyhe Powerbar and after I've enabled "digital power only on s1-s4" I now have access to "Program Powerbar" I choose now "numbering of a digital Powerbar" and set start number to 10 and selects "program now" - now nothing happens - If i push the "ready" button I will come back to the main menu but the numbers has not changed at the Powerbar.
I want to change the number because I also have a 4 unit dosing pump, placed on 1 to 4
This is incorrect! You don't have a digital Powerbar - you have a PowerbarPAB!
Again:
Did you assign the Powerbar to the ProfiLux as mentioned in the PAB guide in section 2.2?
Link: http://www.aquariumcomputer.com/Down...n_PAB_V500.pdf
On the ProfiLux (not ProfiLuxControl):
System->Configure PAB->Assign devices
Thanks, now it working :)
I was not aware that programning the PAB should be done from the Profilux and NOT from the computer interface.
By the way the computer interface is that what you call PLC ?
PLC is the short form for the PC-Software (ProfiLuxControl)