RGB led using 0-10 output and Fibaro controller

Hey!

I have the fibaro RGB W led controller. Basically it comes with 4 0-10v inputs and 4 PWM outputs to control a led strip of up to 140W.

I want to use it to control a backlight panel.

Can I connect the 0-10v outputs from the Profilux 4 to the Fibaro controller? If so:

- what cable do I need to get 3 0-10v outputs from the Profilux?
- the Fibaro RGBW can be configured to have (or not) a pull-up resistor on each 0-10v input. Does the Profilux 0-10v outputs require a pull-up resistor?

Anything else I should keep in mind?

Cheers,

For anyone seeing this in the future, the setup works.

- No pull up resitor needed, i.e. the Fibaro configuration is "no pull up"
- Used rj12 cable (6 wires) and the relevant pins are pins 2 and 5. Pin 3 was also needed for GND. The mapping is

- Port 1. Pin 3 goes to Fibaro GND. Pin 2 goes to Fibaro Input 1. Pin 5 goes to Fibaro input 2
- Port 2: Pin 2 goes to Fibaro Input 3. Pin 5 goes to Fibaro input 4

I'm actually not using the W channel since my led strip is RGB and not RGBW.

Hope it helps anyone in the future!

Hey,

I'm glad you got it working. Thank you very much for updating the thread with your findings.