Help on ProfiLux 4 Touch Buttons

Dear All

Just unpacked and installed ProfiLux 4. All went fine with connections. However when I tried to go to the touch buttons and do the probe calibrations, I was taken aback as the touch buttons weren't working. Ok, so no problem :confused:. Searched net and followed the calibration video for touch buttons! But after that machine goes crazy. See attached video.

https://youtu.be/PAyycb3ilmg

Please please please help me.

Thanks in advance.

When you calibrated, did you press all 6 keys?
These should be pressed one at a time as you would normally press them when you are using them.

Is the controller plugged into a grounded outlet?
Electrical interference can cause this kind of behavior too. Take the controller to a completely different room and try the calibration again.

Quote:

---

Originally Posted by Vinny

When you calibrated, did you press all 6 keys?
These should be pressed one at a time as you would normally press them when you are using them.

Is the controller plugged into a grounded outlet?
Electrical interference can cause this kind of behavior too. Take the controller to a completely different room and try the calibration again.

---

Hi Vinny

Thank you so much for attending this.
This is indeed in grounded connection and I have tested this with a socket tester. We are using also mandatory grounding plugs (like UK).
I have touched all the buttons during my calibration. Kept the device completely not connected with power for sometimes as well before reconnecting.

I will try connecting it to different room once again and check...
Interesting is only the “cancel” button isn’t working when I touch now. Others work even though erratically.