Updating Firmware issues

Hi
Can anyone tell me if updating the firmware on the Profilux 3 would cause a 6d (non pab) powerbar to stop communicating.
Thanks

In very rare cases it can happen that the programming of the powerbar gets changed during the update. In such a case, go to the switch channel settings and click on 'program digital powerbar or dosing pump unit...' to reprogram the powerbar.

Quote:

---

Originally Posted by Thilo

In very rare cases it can happen that the programming of the powerbar gets changed during the update. In such a case, go to the switch channel settings and click on 'program digital powerbar or dosing pump unit...' to reprogram the powerbar.

---

Thanks for your reply, its not the programming that's changed its the powerbar is not communicating with the Profilux. The orange led is out and the green led is flashing. I was just wondering if the powerbar wasn't compatible with 6.41 ProfiLux firmware.

Thanks John

Hi John,

This non-pab powerbar remains compatible for the most current firmware version. As Thilo mentioned, if there is no yellow com light, the powerbar may have to be "programmed" again.