Switch channels not showing Amp reading

Hi
I have 4 devices connected to the PAB but only three are showing the electrical consumption.

The third plug which is connected to my Aqamai wave maker it has a registered consumption of between 4-10 watts. Any reason why this doesn’t show it’s consumption?
The PAB plug is not faulty as it shows results for other appliances.

Thanks


Sent from my iPhone using Tapatalk

10 watt / 230 Volt = 0.04 Ampere

Quote:

---

Originally Posted by Gandalf

10 watt / 230 Volt = 0.04 Ampere

---

Are you say that because it’s using 0.04 amp, that it won’t register on the GHL application ?


Sent from my iPhone using Tapatalk

Bump


Sent from my iPad using Tapatalk

Quote:

---

Originally Posted by Elic173

Are you say that because it’s using 0.04 amp, that it won’t register on the GHL application ?

---

Correct, the minimum is approximately 0.1-0.2A