I meant the Sicce Syncra SDC not the ADV
Can these pumps be controlled by a Profilux 4?
Printable View
I meant the Sicce Syncra SDC not the ADV
Can these pumps be controlled by a Profilux 4?
Hi,
It doesn't look like the SDC model supports 1-10V therefore the ProfiLux would not be able to communicate directly with it to control the flow rate. You can however still connect it to a powerbar socket and set it to turn OFF during events such as feed pauses and maintenance modes.
I did not think so but was hoping I was missing something.
Hello, few months ago a post on the GHL Facebook page showed a GHL cable to connect Profilux to the Sicce SDC pumps. I am building a new system, and would like to know if the idea of a cable to control them has been abandoned before I spend 1200$ on pumps I can’t control with Profilux.
I could imagine that 24V pumps, which are usually controlled via PWM, can be controlled with a LEDControl4V2. But I have not tested them yet. The settings in the GCC would then probably have to be made via the light control. Possible would also be a 1-10V to PWM converter to use the pump control in the GCC.
regards Pit
Attachment 13204
Well this is the post, with the cable, and I was hoping for a pre-made solution from GHL. The thing that puzzles me is that the answer to the facebook post was on May 27th 2021, the reply from Vinny in this post is from August 2021, did they try the cable and it didn't work?
Hi
Cables availables on Sicce store in accessories:
SKT0323/O for XSTREAM SDC
SKT0324/0 for SYNCRA SDC
Gael
I wish they would get them in the SicceUSA store. I was told they would be there in 8 -10 days a month ago.