Printable View
Hallo,
I bought this comoputer and I can't manage with it.
At first I wanted to set up the light. I pressed "sun" after illumination then dimmable. Automatic - yes. then done all as I needed. But it is not working.
Then I wanted to return to factory setting. Watched in instruction, there were written Extras - Factory Setting. When I pressed Extras there were no Factory Setting. Now I am sitting and just dont know what to do.
Someone, explane me, please.
Sincerely,
Lisbeth
Did you set the on off times, in the 1-10 volt ?.
Cheers
Pete
Thank you for the answer.
And what must I do? How many Wolts I must put?
First of all in the illumination you need to set the on off times, then in the 1-10 set the illumination channel. So if in the first illumination channel you set moonlight, then that will be channel 1 on the 1-10 volt.
Hope this helps, if gets better the more you use it.
Cheers
Pete
Sorry.
how can I put this channels?:confused:
I put 8 volts
You plug in your simi stick into L1 L2 the set the on off time and finally assign L1 to moon light L2 sunrise/set leave it set to 1-10volt.
Cheers
Pete
Okei, I understood that.
But can you just explain me step by step. What buttons I must press and so on.
Big thanks.
Hello Lisbeth
If you are living in the Netherlands you can phone me
My name and number are on the website
www.claqua.nl
regards
Piet
Hello,
I have a new question, if i want to connect new lamp to my profilux do i need GHL ActiveL-Splitter? I have already one lamp.
Yes, or you can plug it into another L port.
Cheers
Pete
Sorry just seen it is you Elisabeth, how you doing.
Cheers
Pete
Thank you.
I am fine, thank you. In 3 days going to London for summer. How are you doing?
Sorry, remember you gave some link about some shop?