Printable View
I have an old dali card and wonder now how i can se it it works with the led driver i can get.
When i start up the ghl computer it says
Dali 1.0
Firmwire 5.14
what should i look after so the dali card will work with a led dali driver like this Helvar
LC1x30-E-DA 1x30 W Dimmable DALI LED driver
http://www.helvar.com/sites/default/...es/flag-de.png
Datenblatt (DE)
http://www.helvar.com/sites/default/...es/flag-en.png
Datasheet (EN)
Yes, this driver works
Okey great to hear!
Now the build will start. :)
I want to get rid of my 2x8 watt t5 light in my Giesemann Reflexx Nanomh lamp and plan to out some led insted in that place but one thing i have to solder. The heat from the hqi lamp....
/Christian
So you want to get rid of the 2x8 watt T5, and retain the HQI? Which light color have the T5 ? You need approximately 8 High Power LED 1W 350mA, better 12, and then only operate at 80%.
Yes that was my ide.
The t5 light is 20000kelvin.
My ide was atleast 3watt leds and different blue Nm and some aqtanic
/Christian
You can 3W LED with 700mA use, but you should not mix the colors. Some 3W LED have 3.2Volt, or other 3.4Volt 3.3Volt. The adapter always returns the max. required voltage. The colors of individual LED will no longer be correct. Or they break due to high voltage. Per color 1 power supply would be the right thing, or 3W LED with 20000Kelvin ,like this. Do not forget to pay attention from the temperature
When i shearch at the dali meny it says connected 0 so it dosent fint the driver, Someone ho can ha a clue why it says so
you have to search directly at the Profilux, did you do that?
Yes in the menu system - Dali etc
do the search thing and nothing found
Please have a look at the Profilux user manual / chapter DALI - here it is described in detail,
how the assignment of the electronical ballast works.
Have you wired the ballast correctly to the DALI-card?