Hello and Merry Christmas...
I was wondering if anyone can help me with the following issue
I have setup Profilux to do atomatic water change and also salinity control using special functions
Level1 ATO& Water change
Level2 Not enabled
Level3 Ato Top Of
Timer4 : from 3:00PM to 9:00PM ( Fill Tank With RO/DI Water )
Programmable logic
G1: AND Water1 Water change ( inverted )
G2: AND Water1 Water change
G4: AND Water3 Timer4
G5: AND G1 Conductivity increase
G6: AND G1 Conductivity decrease
G7: OR G2 G6
Socket functions
S1: Pogrammable logic4 ( Fill my 250Lt tank with RO/DI water once a week )
S4: Programmable logic5 ( fill sump with salt water )
S5: Programmable logic7 ( fill sump with RO/DI Water )
S16: Water2 ( Water drain from my sump )
Problem with above senario is that when doing water change it fills up my tank with fresh water ....... not salt water
when using ATO function it is working ok.... meaning that if salinity is below set value it adds salt water
if salinity is above set value then it adds RO water......
can anyone tell me what to do???
Regards
Christos