Printable View
Thanks for the help, I have read this chapter if dali card but now when you write as you do,Quote:
Originally Posted by Carolin
I get hesitant about this contact I bought works. I did not find anyone selling the contact you wrote in a previous post ...
Quote:
Originally Posted by Carolin
Does it matter its just 2 cabels...
Where is the + cabels att the dali card
What is the Numbers of 85 and can you explain what this is about in the dali settings
/Christian
You have a PM.
Fast service. The parcel came today friday with the new IC to the dali card .
unfortunately that was not resolved the problem of ghl card. It will not find dali point address.
I have searched the ghl computer after new address but it finds none. blank page,
Attachment 5689
but when I plug in a t5 driver dali dimmable so you can find this driver. I can test if it's the same problem with another led driver
best regards
Christian
Hello,Quote:
Originally Posted by wrang
unfortunately I don't understand your post.
Does the DALI ballast work now or not? From your statement above I understand that it is recognized, so it should works now...?
Hello.
It works with the T5 light ballast and found a adress 1, but when i connect a led driver with dali it dosent find the adress and the led driver its just a blank view in the display as the picture.
When I connect and try it to the illunination channel the led ligt is on 100% and try to set it to 10% it still light for Max light.
But i will get a new led driver and test with it, it may be the driver witch is broken.
Its the same if i switch the cabel to the dali card
/Christian
Herre is some movie clip when i try to find the driver in the meny
http://youtu.be/8EyJVVs_AVA
/Christian
Obviously the DALI card doesn´t recognize the LED driver due it´s another type of DALI device.
Light tube drivers for T5/T8 are type #1, LED drivers are type #6.-
I don´t know if this is checked by the card or not.
@PIWAWT: Is your statement from post #2 a general statement or have you tested this kind of devices?
Thanks Gunther.
So right the led driver dali is type 6. Hope Caroline/GHL can confirm that it will works with type 6 to
/Christian
Here is what i found about the type
Quote:
Typical field devices
The DALI interface is described in the IEC 62386 standard. The areas of the standard correspond in each case to a connectable type of device:
– Part 201: Fluorescent lamps (device type 0)
– Part 202: Emergency lighting (device type 1)
– Part 206: Conversion of digital signals to DC voltage signals (device type 5)
– Part 207: LED modules (device type 6)