where is the 120V power supply for the Tunze plugged in?
Printable View
where is the 120V power supply for the Tunze plugged in?
In to PB under S10S11
and what settings do these sockets have?
looks like this
http://i27.photobucket.com/albums/c1...r/untitled.jpg
here is other one, one pump in state% but both pumps are " dead"
http://i27.photobucket.com/albums/c173/mshur/seq1.jpg
and what are the 1-10V-settings?
are the Tunzes connected over a ProfiLux-Tunze cable to the ProfiLux? If yes - which ones exactly? How and where?
please give us all needed information now in one step, this would make our work much easier
Here is the settings
http://i27.photobucket.com/albums/c173/mshur/tunze.jpg
One pump connected with T1 and other with T2 going to One splitter and from Spliter to Profilux.
and this splitter is connected to L5L6 ?
if all settings are correct then we must consider that there may be a problem with the splitter - if you connect only 1 Tunze cable directly to L5L6, does the pump work as it should (please test this with both cables/pumps)?
yes, its connected to L54L6
I will teast thsi option tonight and let you know.. maybe you right about the spliter..Did you ever had any problems with GHL spliters?
ok, here what i found
when connected direct they work fine. soon as i use splitter and one pump in state 0 ,both pump are "dead".Only one channel in splitter work( right side) .When i plug it in by one they work fine soon as i plug two pumps they stop working if one got state 0.
If i use "perm opposite" mode they both pumps work fine..
Your thoughts?