Setting up another PAB

I've recently purchased a second hand PowerBar 6D to compliment the two that I already have.

Is there any particular sequence that I need to do to install it other than connecting the ribbon cable and assigning sockets on the PLC ?

Thanks in advance.

T

Just assign ( without other PAB device ) and numbering the socket is OK.

Quote:

---

Originally Posted by Tone

I've recently purchased a second hand PowerBar 6D to compliment the two that I already have.
Is there any particular sequence that I need to do to install it other than connecting the ribbon cable and assigning sockets on the PLC ?
T

---

Yes, You can't just connect and assign it with the other power bar connected.
Only one device can be connected and programmed at a time for the Digital power bar and doser.
So you need to write down what numbers the current power bar and or doser use and then disconnect them.
Connect your new power bar and program it to switch numbers that are not being used by the others.
Reconnect all, and you should be up and running.

Cheers, Paul :)