Printable View
Hi all.
I'm buying a Build My LED fixture and they use constant current dimmable driver. 0-10v.
I have a P3. What do I have to buy to be able to control these lights? I've looked at the available products but I am still lost.
And what is a Western Plug? Is is the electrical plug?
Thanks.
hi:
we have done the build my led. Western Plug is phone type.
at radio shack it is the rj11 plug six wire Telco. connection. note that the cable they sell is not straight through. pin 1 to pin 8 is Telco.
you can use one end and split it out. note if you are not electronics savvy then buy (GHL) their cable and break out parts.
this can be for less the $15.00 there is on this site info on how to use the L1 sockets. one socket will do two lights. on the 3X L1~2
L3~4 and L5~6 are to 0 or 1 to 10 dcv ports.
hope this helps.
Thank you.
I only have 2 L ports.
L1L2 and L3L4 but im only controlling 4 light so this should be OK.
Can you explain to me what I have to do please? Or send me the link to where there is instructions that I can follow?
Did you use LED Control 4 or EVG card?
Thank you very much.
DIY info remember to check your work. in a PDF file