DIY LED - no ligt on Driver 2

Hi

I have two MEAN WELL ELN-60-48D drivers and both are controling 13 Creed LED
I have a GHL proflux II Plus computer to control them

I have connected the drivers to a EVG-AP-2F-HIC ( PL-0556 ) unit


This is how i connected them:

Driver 1: to EVG 1 power supply ballast 1 and ballast 1

Driver 2 : Power supply 2 and Ballast 2

Main power supply: 220v directky from the powerplug in the wall.

When i turn on the Driver-1 on i can hear a "clik" from the EVG-AP and there are lights and i can turn down the light
When i turn on the Driver-2 on i can hear a "clik" agin but no light.

But if i switch so 2 goes to 1 and 1 goes to 2 there is the same problem. no light in ballast 1

I don't use ground wires only + and - wires.

so the problem moves with the ballast? if yes:

EVG-AP works
ballast is defective

The problem stays, so the problem have to be with the EVG-AP

I understood your post in a way that the problem moves with the ballast

if this was not the case then the EVG-AP may be defective

ask your retailer for details how to handle this

they told my to ship it to you. i bought it at http://www.shop-meeresaquaristik.de/

so? what do I do?

I've sent you a PM.