Can I program this sequence of events for a saltwater change?

Hi

I am looking at purchasing the Profilux 3 and need to know if the following sequence can be programmed through the programmable logic on the PC software before purchasing.

I hope some one preferably a moderator could confirm this for me?

Please see attached diagram to understand more fully Attachment 2036

Pump 1 saltwater drain
Pump 2 saltwater fill
Pump 3 auto top off
Pump 4 return pump

Level sensor 1 (auto top) + (second saltwater fill)
Level sensor 2 (leakage detection) + (return pump)
Level sensor 3 (second auto top off) + (Salt water fill level)

Function: saltwater change sequence:




Level sensor 1 (auto top) CHANGES TO (second saltwater fill)
Level sensor 2 (leakage detection) CHANGES TO (return pump)
Level sensor 3 (second auto top off) CHANGES TO (Salt water fill level)

Pump 1 saltwater drain ON

Level sensor 2 (return pump) REACHES LOW LEVEL
Pump 4 return pump OFF

5 mins after function start ie. (Pump 1 saltwater drain ON)

Pump 1 saltwater drain OFF
Pump 2 saltwater fill ON (*Timer starts)

Level Sensor 2 (return pump) RAISES LEVEL
Pump 4 return pump ON

Level sensor 3 (Salt water fill level) or Level sensor 1 (second saltwater fill) REACHES LEVEL
Pump 2 saltwater fill OFF

(If maximum time limit is reached from *Timer start then pump automatically switches off, alarm sounds and email notification that problem has occurred. I no problems occurred then sensors switch back as below)

Level sensor 1 (second saltwater fill) CHANGES TO (auto top)
Level sensor 2 (return pump) CHANGES TO (leakage detection)
Level sensor 3 (Salt water fill level) CHANGES TO (second auto top off)

I would greatly appreciate if someone could tell me if this is possible?