system: P3ex, sw 5.0.6.0
reading of prove are
val 1 0 ms adc1 43,
val 2 49,5ms adc2 34,
i've set the nominal value at 49,5 ms (Density 1.021,4)
Q: why does the probe not view the correct values, now it is 0 Ms. Who can help to solve the issue
system: P3ex, sw 5.0.6.0
reading of prove are
val 1 0 ms adc1 43,
val 2 49,5ms adc2 34,
i've set the nominal value at 49,5 ms (Density 1.021,4)
Q: why does the probe not view the correct values, now it is 0 Ms. Who can help to solve the issue
Val 2 should be much highter than val 1Quote:
reading of prove are
val 1 0 ms adc1 43,
val 2 49,5ms adc2 34,
Thee are three possiblilities (or a combination of it):Quote:
Q: why does the probe not view the correct values, now it is 0 Ms. Who can help to solve the issue
Quote:
calibration is done wrong
a cable is broken
BNC connector is not connected well
i´ve solved my problem, thanks for the tip.