Printable View
I have a skimmer on Socket 3. Everytime the feed pause ends the skimmer overflows and a bunch of skimmate goes into my sump, not a good thing. Is there a way to set socket 3 to delay start after feed pause ends so that the sump level goes to its normal level before the skimmer starts again?
In Programmable Logic G1 =
input : Filter
Time: 480 sec (8 min)
Function: Delay On
Then assign programable Logic 1 to your skimmer socket #3
Thanks, I will try and "program" it but is seems like a round-about solution for a common problem. You should consider making this be an easy check bok for a socket function. Most other controllers have this function readily available.
Is it possible to extend the feed pause timer past 10 minutes, I want it to be 20 minutes.
I believe its already possible to do this ,( at least I had mine @ 14 mins ) but never bothered timing it :)
the max right now is 10 minutes. I wish i could make it 20
Well, I've just tested it and I have my FP @ 15 mins and when I press esc on the controller it counts down from 900 to 0 so that's still 15 mins
I'm using FW 5.07 and PLC 5.07
Quote:
Originally Posted by Blahenazo
yup I tried it, it works. thanks.