Printable View
I got 4xAquaray500 and I am a little confused regarding connecting and controlling them with the profilux3 via the LED-1 controller:
1. Do you use the LED-1 controller instead of the PSU provided with the units?
2. Can you controll 2 aquaray500 units with one LED-1 controller (I have 2 twin units so I have 4 units with 2 PSU)
3. On the LED-1 there is the cable going out and a recepticle market 0-10V. What is it used for?
Thanks,
no, you need both, the controller is inserted between PSU und LEDQuote:
1. Do you use the LED-1 controller instead of the PSU provided with the units?
no, for each LED you need one controllerQuote:
Can you controll 2 aquaray500 units with one LED-1 controller (I have 2 twin units so I have 4 units with 2 PSU)
the outgoing cable is plugged into the PSU, the 1-10V is the control line (brightness) which is connected to the ProfiLuxQuote:
On the LED-1 there is the cable going out and a recepticle market 0-10V. What is it used for?
Thank you Matthias.
It is working OK now. I have a problem with one unit where when in moon simulation it goes off for few seconds and than comes back.
The illumination is setup to 3% at night time and at that time the moonlight simulation is on.
Any idea what could cause the problem?