Printable View
Well my other one was fried onside I can not figure out why. I ordered a new one and got it up friday. It is daisy chained from my first DPB and it also runs my ATO. The power light is on and dosing pump is working. But none of the outlets are working. Any suggestions ?
I replied to your emails but just incase you did not get them here is the most likely issue
From the email text it sounds like you have purchased a new power bar but have not as yet programmed the socket function, if I am on the right track then do the following
Plug new power bar into S1S4 (no other power bar must be plugged in at all)
Go to socket function outlet.
Go to programme digital power bar.
Follow onscreen instructions on how to program the power bar, if you have two power bars the new one i assume you will be programming to start numbering from socket 7. (unless you also have a 4 way power bar)
Plug second power bar into western connection on first power bar and first power bar back into S1-4
Hi Nick,
these are too less information to give you sufficient help.
These are the important points which must be checked:
- is S1-S4 set to "digital" ? - then the yellow LED on any device on the digital bus (all powerbars and dosing units) must be active permanently
- check the start numbering of any device
- check the socket functions