DALI module doesn't recognize Osram ballasts

Hi,

I have a Profilux 3 (firmware 5.00m, using Proflix Control 5.0.0.9) with the PLM-DALI module. To the DALI module are 4 Osram Quicktronic Intelligent 1x 35/49/80 ballasts connected.

In the menu System, the DALI option is available, but when I start "New Numbering" I get a disappointing result: 0 found. When I choose "Assign illumin." all the lights switch off. I tried with another cable, with one ballast, etc. etc, but no other behaviour.

Any ideas what goes wrong? Is the DALI module defective, are the 4 (new) ballasts defective?

Harmjan

all cards are tested befoe shipment - this means a defective PLM-DALI is not very likely
on the other hand it is not very likely that 4 new ballasts are defective

fw 5.00m works great with PLM-DALI

-> is the wiring maybe the problem?

I don't think the wiring is the problem. See attached picture. I tested also with one ballast, no other behaviour.

could you send us the card and at least one ballast?
where are you from?
please contact GHL by email regarding this topic (contact information: http://www.aquariumcomputer.com/Syst...t/contact.html )

Quote:

---

Originally Posted by harmjan

I don't think the wiring is the problem. See attached picture. I tested also with one ballast, no other behaviour.

---

did you solve this problem?
I am having the same issue with similar ballasts

I have send my module and one ballast to GHL. They have repaired the module (defective component) and updated the firmware to 1.02. The Osram ballast was ok. Problem solved!