Profilux 4 screen stuck in endless "start 1-4" feed mode display

I'm running the latest GCC with the latest firmware installed.
I've successfully set up WIFI and have connected several times.

When I turn on my profilux, my display screen goes to the "start 1-4" feeding pause mode display. When I hit the X button, it closes it, and immediatly re-opens the "start 1-4" display. Some things to note:
If i Hit the X button, and immediatly hit the down arrow, I can (sometimes) get into the settings menu. It usually just takes me back to the "start 1-4" page, but sometimes I can get into it.
When in the settings menu, if I hit X, or go into a specific display (such as clock, or sensors) and hit the X button while in the display, it will open the "start 1-4" page for feed mode.
I've tried resetting the device multiple times via unplugging and plugging back in.
I've not done a reset via the settings display.

I have the same issue... as soon as I touch 1 time the display after the screen goes to "start 1-4" ...
if pressed X it will go out but shortly followed back to start 1-4... after several power off unit the menu goos in scroll mode illum... temp... date.. time...

Quote:

---

Originally Posted by dawsokj1988

I'm running the latest GCC with the latest firmware installed.
I've successfully set up WIFI and have connected several times.

When I turn on my profilux, my display screen goes to the "start 1-4" feeding pause mode display. When I hit the X button, it closes it, and immediatly re-opens the "start 1-4" display. Some things to note:
If i Hit the X button, and immediatly hit the down arrow, I can (sometimes) get into the settings menu. It usually just takes me back to the "start 1-4" page, but sometimes I can get into it.
When in the settings menu, if I hit X, or go into a specific display (such as clock, or sensors) and hit the X button while in the display, it will open the "start 1-4" page for feed mode.
I've tried resetting the device multiple times via unplugging and plugging back in.
I've not done a reset via the settings display.

---

Hello,

our development Team will check this issue.

I had the Start 1-4 message a couple of times, I selected YES and it went away. I don't know what it did. I had Wifi set up and used it many times but it dropped out and hasn't connected since. As I am currently setting everything up, I haven't worried about it so far and I don't know if there is a problem or not.

When you hit YES, you turned on a feed mode setting. It goes away when I do this as well, but it always comes back when I X out of any menu.

this has been fixed with firmware 7.04

did you update, OK now?

Yes, it's fixed now as of the new update. Thank you.