PDA

View Full Version : ProfiLux Firmware 6.14


Artur
19.02.2015, 10:24
...is now available for download (https://aquariumcomputer.com/en-GB/ghldownloads?fileID=224).

Changes since version 6.13:

Problem in V6.13 with assignment of Expansion Box over PAB solved
AndreO
17.03.2015, 03:23
just installed 6.14 I am impressed really like the dossing pump info. But I have a problem my PH went to 5.39 but my test pack says 8.1 ( was 8.18)and have lost the touch ( it is still showing all but cannot find it in control or control center) Because I cannot communicate I do not know the version. Thanks for any Help Andre
AndreO
17.03.2015, 04:49
just installed 6.14 I am impressed really like the dossing pump info. But I have a problem my PH went to 5.39 but my test pack says 8.1 ( was 8.18)and have lost the touch ( it is still showing all but cannot find it in control or control center) Because I cannot communicate I do not know the version. Thanks for any Help Andre

found why no touch have to reassign PAB devices still need fix for PH reading. when I did reassign pab the ph went up to 8.10 and then went back down to 5.44 .. also conductivity only reading MS is there away to change setting
GHL Support
17.03.2015, 14:07
If you like to change the measurement range of conductivity (salt or fresh water), then you can do this here in the GHL Control Center:
7198

What does the pH probe show after calibration in the calibration fluids? Is the value correct here?
AndreO
18.03.2015, 03:44
yes once calibrated the ph reading is correct. The conductivity probe I would like to read SE
GHL Support
18.03.2015, 10:58
What do you mean with SE? The conductivity can be displayed as conductivity, salinity or density.
AndreO
19.03.2015, 00:31
What do you mean with SE? The conductivity can be displayed as conductivity, salinity or density.

I would like to display salinity thank you
GHL Support
19.03.2015, 14:17
Ok, then you can set this here:

7202
90reefernyc
13.04.2015, 20:55
Hello
Can I update my controller that is running 5.11 now to this new version right away? Or do i have to do something else?
Also can someone point me in the right direction of how to perform updates on controller? I havent done it in so long I forgot.
Thank you
Jimmy
AndreO
14.04.2015, 05:07
Hello
Can I update my controller that is running 5.11 now to this new version right away? Or do i have to do something else?
Also can someone point me in the right direction of how to perform updates on controller? I havent done it in so long I forgot.
Thank you
Jimmy

you need to know what controller you have and use a usb cable ( do not use wlan) plus search forum for update instructions . Then follow them step by step.
90reefernyc
14.04.2015, 05:18
you need to know what controller you have and use a usb cable ( do not use wlan) plus search forum for update instructions . Then follow them step by step.

I always have used rh rs232 cable is that what you are referring to?
thank you
Jimmy