View Full Version : Conductivity calibration is not an option - card or firmware problem?
My 3.1A ex is running perfectly with all its' 6 level sensors. My conductivity probes are both active and showing sensible measurements, but still I don't get to calibrate. Is it a card or a firmwareproblem - or something else?
Calibration is only possible directly at the PL
There is no way to do it with GHL Control Center or web interface (except remote control of te PL)
Thanks for your reply, Gunther. The issue is that "Calibrate" does not show up at all in the "Sensor Settings" menu on the Profilux itself. Probably this is due to a faulty ex-card or there is some bug in the software? Or something else?
GHL Support
30.01.2015, 11:05
In order that the calibration shows up in the menu, the following must be fulfilled:
-the conductivity measurement must be active
-the sensor must be in a proper condition (e.g. no broken cable)
-the sensor must be connected
Larskn, I have experienced this as well ... it was there, then it disappeared, and then it came back ... it is a mystery. Have you tried to engage it through a reboot?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.