PDA

View Full Version : Nitrate reactor with redox programming logic



comex2020
10.11.2014, 11:14
Hi,

I have a deltec NFP nitrate reactor which i am dosing carbon source using my GHL dosing unit

My redox probe just arrived and I am looking for some help with the programmable logic what i am planning to do is

run the reactor with the redox probe and when the redox reading falls out of rang i was going to use my spare pump on the dosing unit to feed fresh salt water into the reactor

how would i go about the programming for this In my head it sounds easy

1. redox reading goes outside optimal
2. start dosing pump #4
3. redox reading back to optimal stop dosing pump

but how do i put this into the Profilux language

all help appreciated

doggydoc10
07.01.2015, 05:08
Anyone?


Always at Sea

Antipodes
07.01.2015, 07:39
What is the redox potential that your are looking at.
What is the doser pump assignment, what other programmable logics or selections are you currently using using redox and dosing?
To give accurate info, need all info.