comex2020
10.11.2014, 11:14
Hi,
I have a deltec NFP nitrate reactor which i am dosing carbon source using my GHL dosing unit
My redox probe just arrived and I am looking for some help with the programmable logic what i am planning to do is
run the reactor with the redox probe and when the redox reading falls out of rang i was going to use my spare pump on the dosing unit to feed fresh salt water into the reactor
how would i go about the programming for this In my head it sounds easy
1. redox reading goes outside optimal
2. start dosing pump #4
3. redox reading back to optimal stop dosing pump
but how do i put this into the Profilux language
all help appreciated
I have a deltec NFP nitrate reactor which i am dosing carbon source using my GHL dosing unit
My redox probe just arrived and I am looking for some help with the programmable logic what i am planning to do is
run the reactor with the redox probe and when the redox reading falls out of rang i was going to use my spare pump on the dosing unit to feed fresh salt water into the reactor
how would i go about the programming for this In my head it sounds easy
1. redox reading goes outside optimal
2. start dosing pump #4
3. redox reading back to optimal stop dosing pump
but how do i put this into the Profilux language
all help appreciated