PAB Bar issues

[doggydoc10]

I have a PAB bar 6D and I have a small Eheim pump connected to it. I need to see if I can monitor when the pump is not working. Is there a way to program Profilux in order to get an alarm if pump goes bad?
Thanks.

[GHL Support]

Unfortunately, this is currently not possible.

[doggydoc10]

Thank you
Is there a reason why I can't see the volts listed like all my other equipment?

[Antipodes]

Hi Doggydoc,
It is amps you see on the statis page.
But the reason you would not see any current draw, is your pump is only drawing a very small amount and would be below the .1 amp thresshold that the power bar measures.

This monitoring of current flow has been requested a number of times, but they have not addressed this at this time.

[doggydoc10]

Hi antipodes. Thank you very much
That's exactly the answer I was looking for.
Hopefully GHL will address this soon.