Heater set up

[doggydoc10]

Hey guys.
How do I set up heater to turn on if temperature goes lower than 75? I have chiller set up at nominal value 77 F and hysteresis .396. Chiller is connected to S1. I have heater connected to S17. Do I just assign temperature 1 and heater as function?
This will then turn heater on if temperature fall lower than 77?

[GHL Support]

Yes, you assign Temperature 1 and heater to the socket in which your heater is plugged in.

The time point when the heater is switched on depends on the hysteresis. In the case of nominal value 77 F and hysteresis of 0,396, the heater would turn on if temperature falls below 76,80 F.
Please have a look at the ProfiLux manual, chapter Hysteresis.

[doggydoc10]

Thank you