Bricked expansion box?

[keneil01]

I have a large system with 4 power bars (PAB), 8 level sensors, 15 channel LED lights, expansion box, Profilux Touch, Dosing unit and of course a Profilux 3N eX. Lot of cables!

I just came home from vacation and have been following the tread about the new feature in on the Touch. The first I did was to update the touch with 1.05. My problem is that my expansion box was online when I did the upgrade, and now its not working. I can no longer find it in the list where I assign a PAB device.

Is there a way where I can flash the expansion box without a P3 or any other suggestion to get me back on track?

[keneil01]

Anyone?

[Gunther]

See http://forum.aquariumcomputer.com/showthread.php?7362-Expansion-Box-gone-after-firmware-update&p=48157#post48157

[keneil01]

Thanks Gunter. I searched the forum for extention box, not expansion box...

I will try this when i get back from work :-)


Sent from my iPad using Tapatalk HD

[Artur]

Hello,

you should update the expansion box firmware:

1. Remove all PAB devices except the expansion box.
2. Connect with the GCC to your profiLux and click Extras->Firmwareupdate in the PAB tab.
3. Confirm the conditions and open the expension box firmware file.
4. Click Yes on the dialog "Do you want to update an Expension Box now?".
5. The next dialog says:
6410
Disconnect the expansion box from power and connect it again, thereafter click immediately OK.
6. After update assign the expension box again

[keneil01]

Thanks for your help. Im now back on track :-)


Sent from my iPad using Tapatalk HD