Helipad
25.07.2014, 01:15
Hi All,
I would like a little bit of assistance on the following:
I got a chiller "controlled" by a socket in a powerbar.
My settings are as you can see on attached picture 6268
Now the PB turns on as the programmed Hysteresis (26.1ºC which is 0.4 above my nominal temp of 25.7) but for some reason it switches off one to two decimals above nominal temp instead of bring the temp. down to nominal.
I believe all my settings are ok but for some reason it does that. I had try with different nominal figures and still does the same, always start at planned hyst. but always shut down before get temp to nominal figure.
Any help it is very appreciated
Kindly regards
Pedro Ferreira
I would like a little bit of assistance on the following:
I got a chiller "controlled" by a socket in a powerbar.
My settings are as you can see on attached picture 6268
Now the PB turns on as the programmed Hysteresis (26.1ºC which is 0.4 above my nominal temp of 25.7) but for some reason it switches off one to two decimals above nominal temp instead of bring the temp. down to nominal.
I believe all my settings are ok but for some reason it does that. I had try with different nominal figures and still does the same, always start at planned hyst. but always shut down before get temp to nominal figure.
Any help it is very appreciated
Kindly regards
Pedro Ferreira