Mitras x 2 connection

[doggydoc10]

Hey guys. Finally got my two Mitras connected. One is a 6100 and the other a 6200. Can I still connect them as master and slave? And if so guidance?
I was able to connect both of them to my old PC but I haven't been able to connect wirelessly.
Any help would be appreciated.

[gino555]

I currently have a 6100 and a 6200 and was wondering the same, do you run different project files on each of the lamps?

[doggydoc10]

I am hoping I can run one on master and the other one on slave. But I haven't even been able to connect both if them in sync yet. I can program individually but still trying to figure out how to use my P3 wireless card with them!

[gino555]

i think you have to program both as slaves and the P3 is the master

[doggydoc10]

Where and how do I program P3 as the master?

[gino555]

is this any help?


Default Master-Slave-configuration for PLM-PWC
The ProfiLux with a PLM-PWC-card becomes the master.
All lamps which shall be controlled have to be adjusted as "Slave".

Then all slave-lamps will use the illumination- and simulation-settings which are broadcasted from the ProfiLux.

The specific settings (like energy options or simulation time shift) have to be made on the lamp in question, just as before.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

[Matthias]

Thanks Gino, this is right. The Plm-pwc is automatically the master, no settings needed.
All Mitras must be adjusted as Master

A mixed operation of different Mitras in the same group makes no sense since the channels have different colors.

[doggydoc10]

I understand it doesn't make any sense, just trying to see if it can be done.
Trial and error will do
Thanks

[Gunther]

I suggest Matthias wrote "All Mitras must be adjusted as Master" by error. For sure, you have to set all Mitras to Slave if the PLM-PWC control is used