freemchr
30.09.2009, 02:08
Hi Guys,
I currently have two sensors which activate an auto top off and one which is set in case the sump water level gets too high.
The setup is the following:
Sensor 1 : Auto Top Off (10s)
Sensor 2: Not Enabled (0s)
ATO in General
is always active
Alarm:
Time Overdue Activates Alarm - Ticked
Current Sensor States - Sensor 1 - Ticked.
Auto Top Off Pump (in RO/DI Water) is connected to S21 and set to Water 1.
This has been working without any problems for a while. What I find is when the RO/DI container is empty the alarm will sound which will indicate to me to refill the container with RO/DI.
Lately however the alarm has been sounding with a full RO/DI container for no reason. I then have to logon to the Profilux Control Software and reset the alarm for it to top up again.
Any reason why this would be the case?
Thanks in advance.
I currently have two sensors which activate an auto top off and one which is set in case the sump water level gets too high.
The setup is the following:
Sensor 1 : Auto Top Off (10s)
Sensor 2: Not Enabled (0s)
ATO in General
is always active
Alarm:
Time Overdue Activates Alarm - Ticked
Current Sensor States - Sensor 1 - Ticked.
Auto Top Off Pump (in RO/DI Water) is connected to S21 and set to Water 1.
This has been working without any problems for a while. What I find is when the RO/DI container is empty the alarm will sound which will indicate to me to refill the container with RO/DI.
Lately however the alarm has been sounding with a full RO/DI container for no reason. I then have to logon to the Profilux Control Software and reset the alarm for it to top up again.
Any reason why this would be the case?
Thanks in advance.