kevin s
24.02.2014, 15:14
Ok I’m having an issue programing my 6100hv. My three Mitres were runing fine for almost 6 months until last night when I decided to upload a newer project. Once uploaded and saved the project it did not cycle through the time, it remains on one setting. I tried three to four times with no success, then I loaded the factory project and still no success. I end up loading a blank project with zero intensity in order to shut down the system for the night.
There are few things that I did that might be an issue why my lights are not cycling:
1. I screwed up and loaded each light with the same project. They are still two slaves and one master.
2. Once I realized, I loaded the project again in the master light, but still nothing.
3. Also I updated all three lights with a new film wear.
Thanks.
Kevin S
There are few things that I did that might be an issue why my lights are not cycling:
1. I screwed up and loaded each light with the same project. They are still two slaves and one master.
2. Once I realized, I loaded the project again in the master light, but still nothing.
3. Also I updated all three lights with a new film wear.
Thanks.
Kevin S