Renaming things on touch.

[Zanders]

Hello.

Can you please give the touch some love? its getting old and boring!

Renaming of buttons and other things (maintenance 1 could maybe be skim off instead of maintenance 1)
Show timer of how much time there is left on maint 1 on the main page.

Graph buttons don't even display the name if the probe???

I dunno. I just think its a boring piece of equipment and it really could use some love!

[Robert2014]

+1

In addition, I have asked a few times about showing the status of my Vortech pumps but have never received a response.

[mdanielse]

+1

I use a sticky-note:( next to my Touch to remember which buttons controls which piece of equipment in the "manual socketcontrol screen". There haven't been a real "polish" of the Touch in years, sadly enough.
5641

For instance: the wide pH range used in the graph is useless for checking a calciumreactor because off the extreme narrow range it operates in. This I would even call a bug in Touch functionality, not new wanted functionality.
But I think that with the release of the GHL-APP they don't pay that much attention to the Touch anymore.

They are aware off the "problems" and wishes regarding the Touch, but sadly enough they choose not to do anything with it.

The only thing we can do is wait and hope... and perhaps pray:D

[keneil01]

+1

New potentional buyers are also reading this forum before they decide to spend money on expensive GHL products!


Sent from my iPhone using Tapatalk

[carlosing74]

I also think this interface would have a lot more productive if you had those features and could see the status of the level sensors in one quadrant.

[AndreO]

+ 1 it sure would be nice

[Crazy35111]

I have 2 Touches, one on each tank. One of them I was able to rename buttons (no idea how I did it), the other one I cannot figure out. I know this issue must of been fixed but can someone tell me how to do it?

[Raul-7]

Anyone try using a tablet instead of the touch?

[GazzMan]

You can label them
7005
7006
7007

[mdanielse]

Profilux Touch uses the names you put in the "description" field's in GHL Control Center software. So fill in description's for every socket, illumination, maintenance, probes...... etc etc..... the Touch will automatically use those names, and display them.

But you have to run the latest firmware and Control Center software, otherwise it won't work!


I have 2 Touches, one on each tank. One of them I was able to rename buttons (no idea how I did it), the other one I cannot figure out. I know this issue must of been fixed but can someone tell me how to do it?

[AndreO]

I have just installed GCC finally got it to talk to p3 but cannot change button names on touch ( FW1.03) Tonite is the first time I have used GCC ( have always used profilux Control) so it took a bit as could not find save and load.

[Artur]

Profilux Touch uses the names you put in the "description" field's in GHL Control Center software. So fill in description's for every socket, illumination, maintenance, probes...... etc etc..... the Touch will automatically use those names, and display them.

But you have to run the latest firmware and Control Center software, otherwise it won't work!

You need the actual firmware for touch and ProfiLux. To change the descriptions in the touch, you have to enter the description in GHL Control Center.

7190

[AndreO]

I did as you said and it works this is a great update