Powerbar 6D-D Problem

[Johan]

Hi

I have 2xPowerbar 6D-D conected on S1-S4, assign to 1-6 and 7-12. 2xPowerbar PAB assign to 13-24 and dosingpump assign to 25-28

Yesterday i found out that the temperatur hade rised to 27. Found out that the socket (nr9) for "Heater" was on IRL but in ProfiluxControl it was off.

When I set the socket "Always off" nothing is happend. But if I change nr3 to "Always off", nr 3and9 goes off.

So my problem is that nr 7-12 is a copy off nr1-6. I haven´t change annything i the program. The only thing I did yesterday was turn on "Maintenance 1" and change water and turne it of again. Socket 1-6 i turned off in Maintanance 1.

What to do?

/Johan

[GHL Support]

Please check if you have assigned the numbers correctly.
You can assign the numbers via the PC software. Doing this you have to connect only the
Powerbar you like to program to the S-Port, the other one has to be disconnected.
After the first is programmed, you have to disconnect it and connect the other one.
When both are programmed, you can connect again both powerbars to one S-Port.