Leakage sensor to over-ride multiple plugs

[JeremyGelber]

Hi,

I have a leakage sensor which creates an alarm and e-mail when it detects water, and it works just fine.

I want it to turn off various plugs (calcium reactor flow, CO2 solenoid, and peri-pump) when it senses an alarm but I can't figure out how to do that. Some plugs are set to "Always On" and one of them is set to follow a timer program. But I want them ALL to turn off if a leak is detected, irrespective of what their state should be.

Could you please talk me through the programming steps for this?

Thanks!

[reeferqq]

For your reference :

Socket always on with alarm cut
4980

Socket with timer control and with alarm cut
4981

4982

[JeremyGelber]

Thank you.

If I understand correctly, that means ANY alarm will cut the socket off? Is there a way to make it specific just to the leakage sensor? For example, if the temperature gets too low that shouldn't stop my calcium reactor working but if there's a leak detected it's most likely because my calcium reactor has malfunctioned and I want to turn it off!

[reeferqq]

I am afraid it is only " general alarm " can be selected for this purpose, maybe you can disable the alarm alert of the other sensor, so that only the leakage detect sensor can trigger the alarm.

[JeremyGelber]

Understood. I guess I can take the chance that other alarms turn off the reactor.

[JeremyGelber]

What does the "Blackout delay" setting do please?

[reeferqq]

Delay start up after the power resume.

[JeremyGelber]

Thank you