Lukecharris
01.10.2013, 18:11
Hi Im new to Profilux and so far am thoroughly confused....It seems the only thing after about a week of trying i can do is get an accurate temp measurement :(
I Have a problem with my ph probes , im sure im dumb but here goes.
I got my unit about 3 weeks ago, after some help from my lfs i calibrated my first set of ph probes (both in my sump at present) and after trying a few times reading instructions as best i can the readings always came back to ALARM on both with a reading value of ***. very confused i returned these for a set of new ones and after calibrating these new ones and returning them to my sump i get a reading on both of them @ 10.5 . Initially my No 2 Ph probe was on 3 and then over night rose to match the other at 10.5?????? im thoroughly perplexed now and i still need to setup MV all my lighting , chiller co2 ect ect ... Please tell me its not all this hard?
Luke
I Have a problem with my ph probes , im sure im dumb but here goes.
I got my unit about 3 weeks ago, after some help from my lfs i calibrated my first set of ph probes (both in my sump at present) and after trying a few times reading instructions as best i can the readings always came back to ALARM on both with a reading value of ***. very confused i returned these for a set of new ones and after calibrating these new ones and returning them to my sump i get a reading on both of them @ 10.5 . Initially my No 2 Ph probe was on 3 and then over night rose to match the other at 10.5?????? im thoroughly perplexed now and i still need to setup MV all my lighting , chiller co2 ect ect ... Please tell me its not all this hard?
Luke