My powerbar is wierd...

[Zanders]

Hello.

I use 5.17 firmware.

I have a 6 socket power bar connected with a pab cable.
When i program my heater to go on when my temp is to low i set it to socket 1 but it gets activated on socket 2? Same if i assign something to socket 2 its socket 3 that goes on.

If i set anything to socket 1 nothing happens :)

Wat do i do now ?

[Antipodes]

Hello.
Wat do i do now ?

Go to the system page in PLC
4832

Then click on the PAB power par in the upper window and the lower window will show context sensitive buttons.
Click on configuration and makes sure that the socket closest to the end is configured 1 (or what you want it to) and make sure that the rest show consecutive numbers.
4833

That should be it! This is also assuming you don't have a doser or anything else that may use socket numbers! (Note I start from 7 because I have a digital six bar on 1-6)

[Zanders]

I cant see my pab on the first window??

[Zanders]

I searched around and found a tutorial on how to reset my pab devices. All good now!
Thank you for your reply and help!