RichardW
06.06.2013, 23:42
I already own 2 x Mitras HV on my 450L tank that Measure 58"L 23" W, 28" high and currently I have them in this formation [] [] and I can see the spread easily covers both front to back and side to side.
Due to the great growth ect ect I have decided to get a new tank built 118" L (3M) 20" W( 50Cm) 20"H ( 50cm) but here is the issue I was wondering if I change the formation and run them = = = then could I get away with 3 Mitras that would be positioned from Left to right roughly - L 650cm - Middle 1500cm - R 650cm from edge.
I am happy if the edges of the tank are not fully lit as I am running my low Sps islands starting in around 350cm/450cm mark from each edge, due to cost I want to see if I can get away with 3 without is looking £$%^ or cheap
I plan on running the GHL around 10-15cm above water so this will also have an impact on spread (any more then that they burn my eyes when on the sofa :)
I also need to start thinking about bracing so this will be important for me where the GHL's will go
Advice or opinions would be much appreciated
Due to the great growth ect ect I have decided to get a new tank built 118" L (3M) 20" W( 50Cm) 20"H ( 50cm) but here is the issue I was wondering if I change the formation and run them = = = then could I get away with 3 Mitras that would be positioned from Left to right roughly - L 650cm - Middle 1500cm - R 650cm from edge.
I am happy if the edges of the tank are not fully lit as I am running my low Sps islands starting in around 350cm/450cm mark from each edge, due to cost I want to see if I can get away with 3 without is looking £$%^ or cheap
I plan on running the GHL around 10-15cm above water so this will also have an impact on spread (any more then that they burn my eyes when on the sofa :)
I also need to start thinking about bracing so this will be important for me where the GHL's will go
Advice or opinions would be much appreciated