Jenner
25.05.2013, 21:52
We have problems activating the flow sensor!
In the Profiluxcontrol program we have in the "Display" activated the flow sensor in the first line, "Flow-sensor 1" and saved it.
Then in "probe/sensor controls" we go to the Flow-sensor!
Goes to the first line of the Flow-sensor (number 1) and mark it.
Press "Determine calibration"
After putting on a pump on the flow-sensor at 1000-1500 l/h in by-pass, we mark flow-sensor model at 2000 l/h, Mark that it is operated in a bypass.
Change the % to 50 %!
Press save!
Still on the Profilux it says:
Flow 1 = 0 l/h
Please, help, what are we doing wrong???
Also, when going back to the determine calibration, it seems like it has not saved the settings, and we have to do it all over.
It also says in the "Connected at level-sensor" = "Not enabled"
In the Calibration it say 12,44 ml/pulse ? What does that mean, when it at the same time says it is Not enabled???
In the Profiluxcontrol program we have in the "Display" activated the flow sensor in the first line, "Flow-sensor 1" and saved it.
Then in "probe/sensor controls" we go to the Flow-sensor!
Goes to the first line of the Flow-sensor (number 1) and mark it.
Press "Determine calibration"
After putting on a pump on the flow-sensor at 1000-1500 l/h in by-pass, we mark flow-sensor model at 2000 l/h, Mark that it is operated in a bypass.
Change the % to 50 %!
Press save!
Still on the Profilux it says:
Flow 1 = 0 l/h
Please, help, what are we doing wrong???
Also, when going back to the determine calibration, it seems like it has not saved the settings, and we have to do it all over.
It also says in the "Connected at level-sensor" = "Not enabled"
In the Calibration it say 12,44 ml/pulse ? What does that mean, when it at the same time says it is Not enabled???