View Full Version : Skimmer level alarm shut and send e mail
Hi,
I had set up before 5.1.5.2 for the float = sensor 3 on skimmer cup to stop S3 and alarm send e mail skimmer over flow
Pro log G1 = water 3 inverted or filter inverted
It work perfect but now I have choice of filter 1,2,3 ......?
And water is not there any more too?
Sorry but confused with the new Fill ATO and AWC?
Thanks
Richard
aqua_digital
18.03.2013, 12:29
I had the same issue this weekend with weir box overflow, same as you need for skimmer. There is only one way to do this. Water feature i.e water 1 no longer exists :( so you need ATO function set.
1. got to level and set for example set level 1 under function 1 as ATO
2. set max on time to 1 second
3. invert sensor
Go to socket function outlet
Set desired socket to ATO Fill only and numeric value as 1
You are now set.
I have the same problem but when I try your setup it doesn't work.
Here is what I did :
In Level I choose the 1st function and set it to Auto top off, maximum on-time 1sec, Auto top off always active checked, sensor 3 (my float switch is connected on sensor 3).
In level I inverted sensor 3.
In Socket, I choose Fill water(ATO only) value 1.
If I don't invert the function, the skimmer doest start. If I invert it, when the alarm goes off the skimmer only stop for 1 sec.
If I increase the on-time then the skimmer stop for the value the on-time is set and start again even with the alarm on.
The maximum value of the on time is only 8 hrs.
If i can only have the skimmer off for 8 hrs when it overflow I will have to revert back to the old firmware since I sometime leave for many days.
Did I do something wrong or is it really to only way to make it work?
thanks,
Mike
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.