View Full Version : new 5.15 for ProfiLux
Matthias
03.01.2013, 12:25
there is a new version from 03. Jan. 2013:
- also available for ProfiLux II
- only change for P3 compared to the previous 5.15: automatic reset of the LAN connection after 5 minutes receiving no data
-> I hope the connection problems a few users reported can be solved - your feedback is welcome
Thank you Matthias. I'll install this update tonight when I get home and report back ASAP.
Al
It looks like this upgrade has introduced another bug. I have cyclic email notifications enabled via Profilux (Mailing Condition = Always, Send Interval = 6) and when the Profilux Control software is not connected to the device, the device is sending email notifications out every 5 minutes.
I have a Profilux 3ex for reference and running ProfiluxControl 5.1.5.1
Matthias
04.01.2013, 08:31
thanks for the hint, Jason
it seems that the LAN auto reset also restarts the mailing cycle - will be checked and fixed today
Matthias
04.01.2013, 13:58
we fixed the email bug (emails sent periodically after automatic LAN-reset)
the new version 5.15 from today is available in our download section
I upgraded to the new version and still had the "connection reset" problem.
Other than that I can't see any problems with the new FW.
Same here with the last version yesterday, Reset when lan connections.
I thought I posted this here as well but I guess not..
I started tinkering in the PLC and went into "Connections". I created a new one identical to my existing one (TCP/IP) and changed the timeout from 1000 to 20000 which seemed to at least help. I tinkered around with it for over 30 minutes and didn't get a single disconnect.
I thought I posted this here as well but I guess not..
I started tinkering in the PLC and went into "Connections". I created a new one identical to my existing one (TCP/IP) and changed the timeout from 1000 to 20000 which seemed to at least help. I tinkered around with it for over 30 minutes and didn't get a single disconnect.
thanks for this one
I'm having a problem since upgrading to 5.15 on my PII Plus EX. If I reboot the Profilux, I can connect via LAN no problem. However, if I disconnect & try to reconnect a few minutes later it cannot be found. PLC is the latest version. Changing the timeout as per above doesn't help. It will not connect unless I reboot the PII.
It seems I can access the LAN firmware by entering the IP into a web browser for a bit longer than my PII works, but even that stops finding the PII. I've already flashed & reinstalled the firmware with no change.
When I try to access it with Reef Status, I get an error saying "Cannot connect the target actively refused the connection". Not sure if that helps.
GHL Support
27.03.2013, 13:17
This subject is also handled here:
http://forum.aquariumcomputer.com/showthread.php?6717-PII-Plus-EX-Communication-trouble-after-upgrade-to-Firmware-5-15#post44127
When i loaded firmware 5.15 i noticed that the level inputs do not show on the display screen. has anybody else noticed this?
I have two profilux and both do not show the level inputs on the display so it must be a bug in firmware 5.15.
GHL Support
02.04.2013, 07:48
The display content for the level inputs have changed.
But this was not changed in firmware 5.15, it was changed in an earlier version.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.