View Full Version : BNC Cable Extender
Armando Fernandes
26.12.2012, 23:34
Good afternoon,
I wonder if I can use an RG174 50ohm cable's extension to connect the temperature probes, pH and ORP system GHL Profilux.
regards,
Armando
But you must recalibrate the probes
Armando Fernandes
27.12.2012, 09:09
Hello Piwawt,
Recalibrate why? I'm still putting the pipes in the wall where they will run wires and cables as RG58 has a thickness greater than cable RG174, was wondering if I could use to make their extensions to the probes.
Best Regards,
Armando Fernandes
Matthias
27.12.2012, 10:35
recalibration is necessary since the electrical characteristics change with extensions
Armando Fernandes
27.12.2012, 10:38
Hello Matthias,
Ok, but it is possible to use this RG174 cables right? The solution is recablibrate the probes. There is a tutorial to do this operation?
Best Regards,
Armando Fernandes
Yes, the cable ist ok.Calibrate your probe with the extensioncable. Use Sensor Settings/Calibration on your PL, lookthis Manual (http://support.aquariumcomputer.com/downloads/Programming%20guide_V515%20-%20PL3.pdf) Page 5 and 10/11
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.