balthus
17.10.2012, 10:58
Hello,
Since I upgraded to the latest version 5.14, I have lost the program I did that allow to delay the skimmer startup after the feeding pause. Otherwise, when the sump pump start, the level is too high and the skimmer overflow.
I used to delay it 10 to 15min after the feeding.
I also did a backup before upgrading, but since there are new multiple feeding pauses, it seems it was not possible to restore my program :(
If the skimmer is in the socket3, what should I do to make that delay?
I have looked a bit in the forum but didn't find any answer.
Regards,
Since I upgraded to the latest version 5.14, I have lost the program I did that allow to delay the skimmer startup after the feeding pause. Otherwise, when the sump pump start, the level is too high and the skimmer overflow.
I used to delay it 10 to 15min after the feeding.
I also did a backup before upgrading, but since there are new multiple feeding pauses, it seems it was not possible to restore my program :(
If the skimmer is in the socket3, what should I do to make that delay?
I have looked a bit in the forum but didn't find any answer.
Regards,