View Full Version : Problem with my Simu-L
My device does not work and saw that all the wires come loose at the card inside the pipe. Can any kind person tell me how I should solder the back of these wires. there are six wires. and these colors
Orange
Yellow
Green
Black
Brown
Copper-colored
Red
2958
1.
2.
3.
4.
5.
6.
Best regards!
Can someone help me!?
Sent from my iPhone 4S using Tapatalk
GHL Support
15.08.2012, 10:33
Have a look here at this manual, this tells you the pin assignment:
http://support.aquariumcomputer.com/downloads/Manual_EVG-AP2_V400.pdf
Okey but where is nr 1 at top or the bottom and do you confirm that this will work at my Simu-L. I woundt fire up my GHL
Pin
Function
Color
1
+12V
Black
2
Dimming intensity channel 1
Brown
3
GND
Red
4
On/off channel 1 (relay control)
Orange
5
Dimming intensity channel 2
Yellow
6
On/off channel 2 (relay control)
Green
2966
One more picture.
Sent from my iPhone 4S using Tapatalk
Please someone ;)
Sent from my iPhone 4S using Tapatalk
Okey but where is nr 1 at top or the bottom
Normally pin #1 is marked ... the lowest pin on your pictures has a square footprint - all others are circular.
and do you confirm that this will work at my Simu-L
No. No one knows what you have done and if somithing else is destroyed. You can try to repair it on your own risk or ask GHL for service.
Normally pin #1 is marked ... the lowest pin on your pictures has a square footprint - all others are circular.
No. No one knows what you have done and if somithing else is destroyed. You can try to repair it on your own risk or ask GHL for service.
I dosent know what was happend. I will get it work again
This is a GHL support forum, right!??
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.