Gilles
15.07.2009, 20:04
Hello,
I tried to upgrade my firmware with profilux software. Unfortunately, while i was waiting, i missed the "download now" message on the screen. So it failed. I did the firmware upgrade again, not touching my profilux, and then pressed :yes: to download now. This failed..
Now i had no firmware on my firmware. So i opened the housing and did the thing i did a lot of times before. I reconnected the jumper so it short circuited the first 2 pins as stated in the manual.
I started the flasher, set the settings to MB90F867, 4mhz, opened the file (AllProfiLuxII_V406.mhx) and pressed "full operation". I got the message "ok to reset" which is also in the manual. Then, after 1 second; TIMEOUT ERROR.
Now i have no co2 on my plants...
Please reply quick how to solve this, i am from the netherlands. Back PCB: v1.08, front PCB: v1.05
I tried to upgrade my firmware with profilux software. Unfortunately, while i was waiting, i missed the "download now" message on the screen. So it failed. I did the firmware upgrade again, not touching my profilux, and then pressed :yes: to download now. This failed..
Now i had no firmware on my firmware. So i opened the housing and did the thing i did a lot of times before. I reconnected the jumper so it short circuited the first 2 pins as stated in the manual.
I started the flasher, set the settings to MB90F867, 4mhz, opened the file (AllProfiLuxII_V406.mhx) and pressed "full operation". I got the message "ok to reset" which is also in the manual. Then, after 1 second; TIMEOUT ERROR.
Now i have no co2 on my plants...
Please reply quick how to solve this, i am from the netherlands. Back PCB: v1.08, front PCB: v1.05